Table of Contents
Advertisement
7. Bluetooth® Function
This device can be used in conjunction with a smartphone running
the «Microlife Connected Health+» App. The Bluetooth®
connection is automatically active CK after the measurement has
been completed.
To manually activate the Bluetooth®, press START/STOP Pad 1
for 4 seconds until the Bluetooth symbol starts flashing CK.
For more detailed information visit www.microlife.com/connect.
8. PC Link Functions
This device can be used in conjunction with a personal computer
(PC) running the Microlife Blood Pressure Analyzer+ (BPA+)
software.
The memory data can be transferred to the PC by connecting the
monitor via a cable.
If no download-voucher and cable is included download the BPA
software from https://www.microlife.com/technologies/connect/
bpaplus and use a Micro-USB cable.
9. Data Memory
This device automatically stores up to 99 measurement values for
each of the 2 users.
Viewing the stored values
Switch the lock switch AN to «unlock» position. Touch the M-pad
AK briefly. The display first shows «M» BM and an average value.
The device then switches to the last stored value.
Touching the «+» AM or the «-» AL pad repeatedly enables you to
move from one stored value to another. Touch the M-pad again to
exit the memory mode.
Memory full
Pay attention that the maximum memory capacity of 99
memories per user is not exceeded. When the 99 memory
is full, the oldest value is automatically overwritten with the
100th value. Values should be evaluated by a doctor before
the memory capacity is reached – otherwise data will be
lost.
Clearing all values
1. Firstly unlock the device, then select either 1 or 2 with the user
pad 9.
2. Hold down the M-pad AK until «CL» appears and then release
6
the button.
3. Touch the M-pad while «CL» is flashing to permanently clear
all values of the selected user.
Cancel deletion: press START/STOP pad 1 while «CL» is
flashing.
Individual values cannot be cleared.
10.Battery Indicator and Battery change
Low battery
When the batteries are approximately ¾ empty the battery symbol
BK will flash as soon as the device is switched on (partly filled
battery displayed). Although the device will continue to measure
reliably, you should obtain replacement batteries.
Flat battery – replacement
When the batteries are flat, the battery symbol BK will flash as
soon as the instrument is switched on (flat battery displayed).
You cannot take any further measurements and must replace the
batteries.
1. Open the battery compartment 5 at the back of the
instrument.
2. Replace the batteries – ensure correct polarity as shown by
the symbols in the compartment.
3. To set date and time, follow the procedure described in
«Section 3.».
The memory retains all values although date and time must be
reset – the year number therefore flashes automatically after
the batteries are replaced.
Which batteries and which procedure?
Use 4 new, long-life 1.5V, size AAA batteries.
Do not use batteries beyond their date of expiry.
Remove batteries if the instrument is not going to be used for
a week or more.
Using rechargeable batteries
You can also operate this instrument using rechargeable batteries.
Only use «NiMH» type reusable batteries.
Batteries must be removed and recharged when the flat
battery symbol appears. They should not remain inside the
instrument as they may become damaged (total discharge as
Advertisement
Table of Contents
