Accessing Internal Components - Toro 320-D Operator's Manual

Accessing Internal
Components
WARNING
Opening or removing covers, hoods, and
screens while the engine is running could
allow you to contact moving parts, seriously
injuring you.
Before opening any of the covers, hoods, and
screens, shut off the engine, remove the key
from the key switch, and allow the engine to
cool.
Removing the Front-Access Cover
1. Park the machine on a level surface and engage
the parking brake.
2. Raise the loader arms and install the cylinder
locks.
Note:
If you must remove the front-access
cover without raising the loader arms, be very
careful not to damage the cover or hydraulic
hoses as you maneuver the cover out from
under the arms.
3. Shut off the engine and remove the key.
4. Release the 2 locking tabs
tab illustrated).
Figure 22
1. Cover
5. Pull the cover off the machine.
6. When finished, replace the front-access cover
and secure it with the 2 locking tabs.
(Figure 22, top, left
g005943
2. Locking tab
Opening the Rear-Access Cover
1. Park the machine on a level surface, engage the
parking brake, and lower the loader arms.
2. Shut off the engine and remove the key.
3. Release the 2 locking tabs on top of the
rear-access cover
1. Rear-access cover
2. Locking tabs
4. Remove the bolt located next to the right locking
tab (Figure 23).
5. Grasping the handle, pull the cover up and back
to swing it open
6. When finished, close the rear-access cover by
swinging it up and seating it in place.
7. Secure it with the 2 locking tabs and bolt.
27
(Figure 23).
Figure 23
3. Bolt
(Figure 23).
g005957