Accessing Internal Components - Toro TX 525 Operator's Manual

Removing and Storing the
Cylinder Lock
Important:
Remove the cylinder lock from the rod
and fully secure it in the storage position before
operating the machine.
1. Start the engine.
2. Raise the loader arms to the fully raised position.
3. Shut off the engine and remove the key.
4. Remove the lynch pin securing the cylinder lock.
5. Rotate the cylinder lock up to the loader arm
and secure it with the lynch pin.
6. Lower the loader arms.
Accessing Internal
Components
WARNING
Opening or removing covers, hoods, and
screens while the engine is running could
allow you to contact moving parts, seriously
injuring you.
Before opening any of the covers, hoods, and
screens, shut off the engine, remove the key
from the key switch, and allow the engine to
cool.
Opening the Hood
1. Loosen the hood-locking screw
1. Hood
2. Hood-latch lever
2. Turn the hood latch clockwise
3. Swing the hood up
24
(Figure
Figure 24
3. Hood-locking screw
(Figure 24).
(Figure 24).
24)
g009691