Toro 320-D Operator's Manual page 34

Charging the Battery
Important:
Always keep the battery fully charged
(1.265 specific gravity). This is especially
important to prevent battery damage when the
temperature is below 0°C (32°F).
1. Remove the battery from the machine; refer to
Removing the Battery (page
2. Charge the battery for 10 to 15 minutes at 25 to
30 A or 30 minutes at 4 to 6 A
not overcharge the battery.
Figure 36
1. Positive battery post
2. Negative battery post
3. When the battery is fully charged, unplug
the charger from the electrical outlet, then
disconnect the charger leads from the battery
posts (Figure 36).
33).
(Figure 36). Do
g003792
3. Red (+) charger lead
4. Black (-) charger lead
Cleaning the Battery
Note:
Keep the terminals and the entire battery case
clean, to help extend battery life.
1. Park the machine on a level surface, engage
the parking brake (if equipped), and lower the
loader arms.
2. Shut off the engine and remove the key.
3. Remove the battery from the machine;
Removing the Battery (page
4. Wash the entire case with a solution of baking
soda and water.
5. Rinse the battery with clear water.
6. Coat the battery posts and cable connectors with
Grafo 112X (skin-over) grease (Toro Part No.
505-47) or petroleum jelly to prevent corrosion.
7. Install the battery; refer to
(page 34).
Installing the Battery
1. Install the battery onto the platform
2. Secure the battery in the chassis with the bars
and nuts removed previously
3. Using the fasteners previously removed, install
the positive (red) battery cable to the positive (+)
battery terminal
4. Slide the red terminal boot onto the positive
battery post.
5. Using the fasteners previously removed, install
the negative (black) battery cable to the negative
(-) battery terminal
6. Install the battery cover
Important:
Ensure that the battery cables do not
contact any sharp edges or each other.
Servicing a Replacement Battery
The original battery is maintenance-free and does not
require service. For servicing a replacement battery,
refer to the battery manufacturer's instructions.
34
33).
Installing the Battery
(Figure
(Figure 35).
(Figure 35).
(Figure 35).
(Figure 35).
35).