Performing Daily Maintenance; Adjusting The Thigh Support - Toro 320-D Operator's Manual

Filling the Fuel Tank(s)
1. Park the machine on a level surface, engage
the parking brake (if equipped), and lower the
loader arms.
2. Shut off the engine, remove the key, and allow
the engine to cool.
3. Clean around the fuel-tank cap and remove it
(Figure 11).
1. Fuel-tank cap
4. Fill the tank to about 2.5 cm (1 inch) below the
top of the tank, not the filler neck, with fuel.
Important:
This space in the tank allows
fuel to expand. Do not fill the fuel tank
completely full.
5. Install the fuel-tank cap securely, turning it until
it clicks.
6. Wipe up any spilled fuel.
Performing Daily
Maintenance
Before starting the machine each day, perform the
Each Use/Daily procedures listed in the
(page 25).
Important:
Check the hydraulic-fluid level
and bleed the fuel system before starting the
engine for the first time; refer to
Hydraulic-Fluid Level (page 38)
Fuel System (page 32).
Figure 11
Maintenance
Checking the
and Bleeding the
Adjusting the Thigh
Support
To adjust the thigh support
the knobs and raise or lower the support pad to
the desired height. You can also obtain additional
adjustment by loosening the nut securing the pad
to the adjustment plate and moving the plate up or
down as needed. Tighten all fasteners securely when
finished.
g237886
1. Thigh-support bracket
2. Adjustment plate
3. Thigh-support pad
17
(Figure 12), loosen
Figure 12
4. Knob and flat washer
5. Carriage bolt
6. Locknut and flat washer
g006054