Performing Daily Maintenance; During Operation; During Operation Safety - Toro TX 525 Operator's Manual

4. Fill the tank to about 2.5 cm (1 inch) below the
top of the tank, not the filler neck, with fuel.
Important:
This space in the tank allows
fuel to expand. Do not fill the fuel tank
completely full.
5. Install the fuel-tank cap securely, turning it until
it clicks.
6. Wipe up any spilled fuel.
Performing Daily
Maintenance
Before starting the machine each day, perform the
Each Use/Daily procedures listed in the
(page 22).
Important:
Check the hydraulic-fluid level
and bleed the fuel system before starting the
engine for the first time; refer to
Hydraulic-Fluid Level (page 43)
Fuel System (page 30).

During Operation

During Operation Safety

General Safety
•
Do not carry a load with the arms raised. Always
carry loads close to the ground.
•
Do not exceed the rated operating capacity, as the
machine may become unstable, which may result
in loss of control.
•
Use only Toro-approved attachments and
accessories. Attachments can change the stability
and the operating characteristics of the machine.
•
For machines with a platform:
– Lower the loader arms before stepping off the
platform.
– Do not try to stabilize the machine by putting
your foot on the ground. If you lose control of
the machine, step off the platform and away
from the machine.
– Do not place your feet under the platform.
– Do not move the machine unless you are
standing with both feet on the platform and your
hands are holding onto the reference bars.
•
Use your full attention while operating the
machine. Do not engage in any activity that
causes distractions; otherwise, injury or property
damage may occur.
•
Look behind and down before backing up to
ensure that the path is clear.
Maintenance
Checking the
and Bleeding the
15
•
Never jerk the controls; use a steady motion.
•
The owner/user can prevent and is responsible
for accidents that may cause personal injury or
property damage.
•
Wear appropriate clothing including gloves, eye
protection, long pants, substantial slip-resistant
footwear, and hearing protection. Tie back long
hair and do not wear loose clothing or loose
jewelry.
•
Do not operate the machine when you are tired, ill,
or under the influence of alcohol or drugs.
•
Never carry passengers and keep pets and
bystanders away from the machine.
•
Operate the machine only in good light, keeping
away from holes and hidden hazards.
•
Ensure that all the drives are in neutral and engage
the parking brake (if equipped) before starting the
engine. Start the engine only from the operator's
position.
•
Use care when approaching blind corners, shrubs,
trees, or other objects that may obscure vision.
•
Slow down and use caution when making turns
and crossing roads and sidewalks. Watch for
traffic.
•
Stop the attachment when you are not working.
•
Stop the machine, shut off the engine, remove
the key, and inspect the machine if you strike
an object. Make any necessary repairs before
resuming operation.
•
Never run an engine in an enclosed area.
•
Never leave a running machine unattended.
•
Before leaving the operating position, do the
following:
– Park the machine on a level surface.
– Lower the loader arms and disengage the
auxiliary hydraulics.
– Engage the parking brake (if equipped).
– Shut off the engine and remove the key.
•
Do not operate the machine when there is the risk
of lightning.
•
Operate the machine only in areas where there is
sufficient clearance for you to safely maneuver.
Be aware of obstacles in close proximity to you.
Failure to maintain adequate distance from trees,
walls, and other barriers may result in injury as the
machine backs up during operation if you are not
attentive to the surroundings.
•
Check for overhead clearance (i.e., electrical
wires, branches, and doorways) before driving
under any objects and do not contact them.
•
Do not overfill the attachment and always keep the
load level when raising the loader arms. Items in
the attachment could fall and cause injury.