Vertiv Liebert DPM User Manual page 75

Table 10.2 PBM Events (continued)
Component Subcomponent
PBM Mains
—
Label
PBM Mains
—
Label
PBM Mains
—
Label
PBM Mains
—
Label
PBM Mains
Breaker # Label
Label
PBM Mains
Breaker # Label
Label
PBM Mains
Breaker # Label
Label
PBM Mains
Breaker # Label
Label
Table 10.3 SFM User Events
Component Subcomponent
SFM Panel
—
Name
SFM Panel
—
Name
SFM Panel
—
Name
SFM Panel
—
Name
SFM Panel
—
Name
SFM Panel
—
Name
SFM Panel
—
Name
SFM Panel
—
Name
10 Faults, Warnings and Events
Type Event Name ID Definition
Main
Status Breaker 209 The Panel Main Breaker Aux lines are reported open.
Open
Main
Status Breaker 210 The Panel Main Breaker Aux lines are reported closed.
Closed
Main
Fault Breaker 211 The Panel Main Breaker Bell sensing has changed state (normal to tripped).
Tripped
The Panel Main Breaker sensing is an erroneous state. Parametric data logged with
Main this event will indicate the nature of the first cause. Error Type: 1 = Form C position
Fault Breaker Acc 212 (Aux) sensing is not complementary. 2 = Form C trip (Bell) sensing is not
Error complementary. 3 = Trip (Bell) sensing is indicating a tripped breaker but the position
(Aux) sensing is indicating a closed breaker.
Fault Overcurrent 232 One of the breaker I rms phases has exceeded the alarm setpoint for the set period.
Alarm Overcurrent 233 One of the I rms phases has exceeded the warning setpoint for the set period.
Fault Undercurrent 234 All of the I rms phases are below the setpoint for the set period.
Energy
The kWH Total measurement has exceeded its maximum value. Parametric data 1
Status Measure 235
indicates panel. Parametric data 2 indicates breaker (1-84).
Rollover
Type Event Name ID Latching
Fault Overvoltage 300 L
Fault Undervoltage 301 L
Phase
Fault 302 L
Overcurrent
Phase
Alarm 303 L
Overcurrent
Neutral
Fault 304 L
Overcurrent
Ground
Fault 305 L
Overcurrent
Frequency
Fault 306 L
Deviation
Summary
Alarm 307 N
Alarm
Definition
One of the VLL rms phases has exceeded the setpoint for the set period.
One of the VLL rms phases is below the setpoint for the set period.
One of the I rms phases has exceeded the alarm setpoint for the set
period.
One of the I rms phases has exceeded the warning setpoint for the set
period.
The In rms has exceeded the alarm setpoint for the set period.
The Ig rms has exceeded the alarm setpoint for the set period.
The measured frequency has fallen outside the range specified in the
frequency setpoint
The occurrence of any subfeed or subfeed main alarm (activeLatched).
71