Advertisement
PHASE 1 | Concur Assembly
Step 1
Select one leg (A) and attach it to the middle
frame (B) with one of the D screws. Tighten a bit
but not completely.
Insert a second D screw and loosely tighten.
Now tighten both (D) screws completely.
Next, tighten the (E) screws in the same method
you used for the (D) screws, leaving loose until
all 4 are in place and then tightening.
Repeat with the other leg.
Step 2
Twist to insert the (C) push button bracket,
followed by the button cover. Repeat on the
other side.
1
A
Detail
D
2
Detail
CONCUR INSTALLATION GUIDE | 3
3
B
D
E
Detail
A
E
D
4
H
C
Detail
If Installing Modesty Panel:
Step 3
Connect the Panel Brackets (K) to the middle
frame (B), locking it with the (L-1) screws (x2).
Connect the Modesty Panel (J) and panel
brackets with the (L) screws (x4).
Step 4
Turn the work surface upside down and center
align the Worksurface Support (F) using the (G)
screws (x2). Now turn the leg and middle frame
assembly upside down. Attach the worksurface to
the cantilevers of the frame assembly using the (I)
screws (x6). Insert the castors firmly into the legs
until locked in place.
Step 5
Turn your finished CONCUR table over to use.
J
L-1
K
L-1
L
K
L
L-1
L
H
I
H
H
I
G
F
5
amqsolutions.com
Advertisement
