Connect via Mobile Client
Add a control panel to the mobile client.
On the control panel settings page, Click +, scan the QR code on
the wirless device or enter the serial No. of the device.
Note
for details, refer to the chapter ofConfiguration-Configuration via
Mobile Client-Add Peripheral to the Control Panel.
1.4 Installation
Steps
1. Loosen the screw on the rear cover. Slide down the rear cover
and remove it from the control panel.
2. Insert a SIM card into the SIM card slot.
3. Connect the battery to the control panel.
4. Connect the power adapter to the control panel and a power
outlet. The power indicator turns green after about 30 s, which
means that the device is powered on.
Note
The condition of no SIM card, no battery, AC power off, or
network disconnected, will cause Control Panel Fault.
Figure 1-4 Remove the Rear Cover
Figure 1-5 Insert SIM Card
Figure 1-6 Connect the Battery
6