Unauthorized Modification Of Spare Parts; Inadmissible Modes Of Operation; Electrostatic Discharge; General Hazard Note - Residual Risk - BEKA PICO Series Operating And Assembly Manual

Check the surfaces temperature of the central lubrication pump as a possible heat transfer bears the risk of
burns. Wear heat resistant Protective gloves!
Open flame and fire are strictly forbidden during maintenance, inspection and repair due to fire hazard.
3.6

Unauthorized modification of spare parts

Modification, repair and alterations of the central lubrication pump are only accepted after manufacturer
feedback. Original spare parts and authorized accessories from the manufacturer contribute to safety. The
use of other parts can result in the loss of any liabilities for the resulting consequences. BEKA does not
assume liability for parts that are retrofit by the operator.
3.7

Inadmissible modes of operation

The operational safety of the central lubrication pump is only guaranteed for appropriate application as indicated in the
operating manual. Never exceed or fall below the limit values, as stated in the technical data.
3.8

Electrostatic discharge

Avoid electrostatic discharge! There are electronic components integrated into the central lubrication pumps
which might be destroyed by electrostatic discharge. Observe the safety precautions against electrostatic
discharge according to DIN EN 61340-5-1/-3. Ensure that the environment (persons, workplace and packing)
is well grounded when handling these central lubrication pumps.
3. 9

General hazard note - residual risk

All components are designed according to valid regulations of the construction of technical systems in
regards to operational safety and accident prevention. Independently from this the use can lead to hazards
for the user or third parties as well as for other technical facilities. Therefore the central lubrication pump may
only fulfill its intended use in a
adherence of the according safety regulations and under observance of the operating manual. Inspect the
central lubrication pump and its attachment parts
leakages. Liquids
© BEKA 201 6 All rights reserved
technically acceptable and faultless condition
could escape under high pressure
!
regularly and check them for possible
from pressurized components which become
. This has to happen in
damage or
leaky .