General Safety Instructions; Safety Instructions; Qualification And Training Of Staff - BEKA PICO Series Operating And Assembly Manual

3.

General safety instructions

All persons that are in charge with the assembly, start-up, maintenance and operation of the central lubrication pump
must carefully read these instructions. Furthermore this operating manual always has to be available on site!
Basic notes for the setup, operation and maintenance can be found below!
3.1

Safety instructions:

Please observe the safety instructions within this main point as well as special safety instructions that are included in
other parts of this documentation.
Warning of electrical voltage
Safety instructions which in case of non-observance might cause hazards to persons are marked with the
general danger symbol.
This symbol warns of hot surfaces.
Warning of suspended loads.
Warning of damage to property due to electrostatic discharge! Marks potential risks which may result in
material damage, if not avoided.
This heading is used if the improper or general non-observeance of the operating manual,
specified work flow and the like
Caution!
This term is used to point out particular details.
Note!
Instructions which are directly attached to the central lubrication pump have to be strictly observed and kept in
readable condition!
3.2

Qualification and training of staff

The staff in charge for operation, maintenance, inspection and assembly has to have the according
qualification for these works. Competence, area of authority and staff monitoring must exactly be controlled
by the operator. In case the staff does not have the necessary knowledge it has to be instructed and trained.
The operator is obliged that the staff fully understands the content of this user information.
© BEKA 201 6 All rights reserved
might result in central lubrication pump damage.
!