Planetary Drive Assembly - Toro Groundsmaster 4500-D Series Service Manual

Planetary Drive Assembly

g310077
1. Flange head screw (6 per planetary) 7.
2. Splined brake shaft
3. Planetary assembly (2 used)
4. Front wheel assembly (2 used)
5. Lug nut (8 per wheel)
6. Retaining ring
Removal (Figure 235)
Axles, Planetaries and Brakes: Service and Repairs
Spring plate
8. Compression spring
9. Jam nut
10. Brake assembly (LH shown)
11. Flange head screw (4 per brake)
12. Gasket
Note: The planetary drive assembly can be serviced with the planetary installed
to machine (see VA02 Series Planetary Drive Service (page
following procedure to remove and install the planetary drive assembly from
the machine.
1. Park machine on a level surface, lower cutting decks, stop engine and
remove key from the ignition switch.
2. Drain the oil from the brake assembly and the Planetary drive; refer to the
traction unit Operator's Manual.
Figure 235
13.
14.
15.
16.
Page 7–8
Piston motor (2 used)
Flat washer (2 per motor)
Cap screw (2 per motor)
Brake cable (LH shown)
7–11)). Use the
Groundsmaster ® 4500-D/4700-D
19245SL Rev A