Toro Groundsmaster 4500-D Series Service Manual page 379

Rear Axle Service (continued)
1. LH axle support
2. Flange bushing (2 used)
3. Axle vent
4. Filter
5. Vent extension
6. Cap screw (4 used per gear case) 28.
7. Shim set
8. Seal washer
9. Plug
10. Lock nut
11. Lock washer
12. Grease fitting
13. Ball bearing
14. Screw (2 used per steering arm)
15. Axle case support (LH shown)
16. Bolt (2 used)
17. Stud (2 used)
18. Shim set
19. Differential assembly
20. O−ring
21. Plug
22. O−ring
Groundsmaster ® 4500-D/4700-D
19245SL Rev A
Figure 244 (continued)
23. RH axle support
24. Input shaft assembly
25. Bolt (8 used)
26. O−ring
27. Differential shaft (LH shown)
Shim set
29. Ball bearing
30. Bevel gear (15 tooth)
31. Retaining ring
32. Bolt (4 used per knuckle)
33. Shim set
34. Dowel pin (2 used per axle case)
35. Bushing
36. Knuckle pin
37. O−ring
38. Bevel gear case (LH shown)
39. Bushing
40. Shaft seal
41. Stud (2 used per gear case)
42. Bolt (4 used per cover)
43. Collar
44. Bevel gear (17 tooth)
Note: Figure 244 illustrates the rear axle used on the Groundsmaster 4500−D
and 4700−D. Service procedures for the rear axle is on the following pages of
this section.
45.
46.
47.
48.
49.
50.
51.
52.
53.
54.
55.
56.
57.
58.
59.
60.
61.
62.
63.
64.
Page 7–21 Axles, Planetaries and Brakes: Service and Repairs
Bevel gear shaft
Axle case (LH shown)
Ball bearing
Bevel gear (29 tooth)
Shim set
Clip (2 used per axle case)
Axle cover
Screw (6 used per cover)
Wheel stud (5 used per axle)
Axle
Oil seal
Ball bearing
O−ring
Retaining ring
Spacer
Axle case cover
Seal washer
Plug
Bevel gear (17 tooth)
O−ring