Toro Groundsmaster 4500-D Series Service Manual page 96

Engine Installation
Yanmar Diesel Engine: Service and Repairs
(Figure 19) (continued)
9. Connect the following engine electrical components:
A. The engine wire harness to the machine wire harness.
B. The positive battery cable and fusible link harness to the engine starter
motor.
C. The negative battery cable, engine ground cable and main wire harness
ground wires to the right side of the engine below the starter motor with
external lock washer and cap screw. Lock washer should be positioned
next to engine casting.
10. Using notes taken during engine removal, secure wires with cable ties in
proper locations.
11. Install air cleaner system to engine (see
12. Connect coolant hoses to the radiator. Make sure radiator draincock is
closed. Fill radiator and reservoir with coolant.
13. Check position of wires, fuel lines and hydraulic hoses for proper clearance
with rotating, high temperature and moving components.
14. Connect positive battery cable to battery first and then negative battery cable.
Secure battery cover to machine.
15. Check and adjust engine oil level as needed.
16. Bleed air from the cooling system. Check and adjust the coolant levels
accordingly.
17. Check and adjust hydraulic reservoir oil level as needed.
18. Prime the fuel system (see
19. Start engine and operate hydraulic controls to properly fill hydraulic system
(see Charge Hydraulic System (page
20. Install hood onto the machine (see
hood.
Air Cleaner System (page
Priming the Fuel System (page
5–95)).
Hood (page
Page 4–24
4–9)).
4–13)).
8–26)). Close and secure
Groundsmaster ® 4500-D/4700-D
19245SL Rev A