Resistor Assembly
Testing
Electrical System: Component Testing
g276036
1.
Resistor assembly
The engine wire harness also contains a 1.6K ohm resistor that is necessary for
ignition switch operation. The resistor plugs into the wiring harness near the
engine starter motor (see
The resistor assemblies can be identified by their gray color, resistor symbol and
Toro part number on the end of the resistor assembly body.
The resistor can be tested using a digital multimeter (ohms setting). The
resistance across the resistor terminals should be 1.6K ohms.
2
Figure 224
2.
End of resistor body
Appendix A (page
A–1)).
Page 6–64
1
Groundsmaster
®
4500-D/4700-D
19245SL Rev A