Adjustments; Traction Pedal Adjustment - Toro Groundsmaster 4500-D Series Service Manual

Adjustments

Traction Pedal Adjustment

Groundsmaster ® 4500-D/4700-D
19245SL Rev A
g309420
1. Traction pedal
2. Pedal position sensor
3. Hex nut
The traction pedal includes a neutral assembly that is used to adjust the traction
neutral position (Figure
make sure that traction pedal movement provides the correct full reverse and full
forward positions for the traction pedal position sensor. The InfoCenter display
can be used to check traction pedal adjustment using the following procedure.
1. Park machine on a level surface, lower cutting decks, engage parking brake
and stop engine.
2. Turn ignition switch to RUN but do not start engine.
g309421
3. Use the InfoCenter Display Diagnostics menu (see
6–8)) to obtain and select the Traction Pedal menu item. Choose Inputs and
the InfoCenter display should identify sensor voltage
4. Move traction pedal from full reverse to full forward positions while noting the
range of voltage displayed on the InfoCenter.
Figure 179
4. Rod end bearing
5. Spring shaft
6. Spring shaft hex
179). Traction pedal adjustment may be necessary to
Traction Pedal
2.407V
Figure 180
Page 6–19
InfoCenter Display (page
(Figure 180).
Electrical System: Adjustments