Remove Internal Hard Drives; Extend The System From The Cabinet; Remove The System Cover - Dell EMC DP4400 Service Procedures

Remove internal hard drives

Extend the system from the cabinet

This procedure is used to extend the system from the cabinet so that the system cover can be
removed to access the internal FRU components, or used in removing the system from the
cabinet.
Procedure
1. At the front of the cabinet, locate the two slam latches on the left and right sides of the
2. Using the slam latches, pull the system from the cabinet until the rails lock in the extended

Remove the system cover

Procedure
1. Using a flat or a Phillips head screwdriver, rotate the latch release lock counter clockwise to
2. Lift the latch till the system cover slides back and the tabs on the system cover disengage
3. Hold the cover on both sides, and lift the cover away from the system.
system. Pull the slam latches up to release the system from the cabinet. If the slam latches
do not disengage, loosen the screw under each latch.
position.
the unlocked position.
from the guide slots on the system.
Dell EMC Integrated Data Protection Appliance DP4400 Service Procedures
Remove and replace assemblies
27