Download Using Soloporter - Sentek EnviroSCAN SOLO Hardware Manual

a) Select Sentek Plus/Multi/Solo (Cable)
b) Select the communications port to which the download cable is plugged
c) Keep the Baud rate at 9600 (This is the default baud rate of the RS232 probe)
d) Type the Logger ID or you can leave blank and Data Exchange will find the probe ID. This is the
same Logger ID that was set on the Logger tab of PConfig when configuring the probe. After the first
download for each Logger, the Logger ID should appear in the pull-down menu for future downloads.
e) Select IrriMAX Database (sdb) as the destination
f) If downloading for the first time browse to the location you want the database saved and type in a
database name. If you are downloading into an existing database Browse to the location of the
database on your computer and select the database.
g) Click Start to commence the download.
h) Once the download is finished, select "Quit". Disconnect cable and replace protective caps on cable
and Solo Head Unit.

Download Using SoloPORTER

1. Make sure the 9V battery and USB flash drive are installed in the SoloPORTER
2. Remove the battery cap from the SoloPORTER and the protective cap from the Solo Head Unit. Plug the
SoloPORTER into the Head Unit.
Copyright © 2008-2012 Sentek Pty Ltd All rights reserved
System Setup
Downloading Readings from Probe
Page 12