SuperATV Half Windshield Installation Instructions

SuperATV Half Windshield Installation Instructions

For can-am maverick x3
Hide thumbs Also See for Half Windshield:

Advertisement

2753 Michigan Road • Madison, Indiana 47250 • 812-574-7777
SuperATV does not recommend keeping Windshield installed while transporting on an open air trailer.
2x - Clamp
4x
M6 Sealing Washer
Read instructions and view illustrations before beginning.
Need help with your installation?
sales@superatv.com
1-812-574-7777
Thank You
®
© 2016 SuperATV.com
. All Rights Reserved.
Use hand tools only when assembling.
Do not use power tools.
4x
www.superatv.com
8:00am - 9:00pm EST M-Th
8:00am - 7:00pm EST Friday
9:00am - 2:00pm EST Saturday
For Choosing
INSTALLATION INSTRUCTIONS
Half Windshield:
Windshield
M6-1.0 x 20mm Lg. BHCS
Liability Statement
SuperATV's
products are designed to best fit user's ATV/UTV under stock
®
conditions. Adding, modifying, or fabricating any factory or aftermarket parts will
void any warranty provided by SuperATV
products could interfere with other aftermarket accessories. If user has aftermarket
products on machine, contact SuperATV
Although SuperATV
that installing lift kits, long travel, or suspension kits, tires, etc. will change the ride
of machine and may increase maintenance and part wear. Operating any off-road
machine while, or after, consuming alcohol and/or drugs increases risk of bodily
harm or death. No warranty or representation is made as to this product's ability to
protect user from severe injury or death. SuperATV
to wear a helmet and appropriate riding gear at all times.
By purchasing and installing SuperATV
occur, SuperATV
replacement parts, or freight charges. SuperATV
responsible for any direct, indirect, incidental, special, or consequential damages
that result from any product purchased from SuperATV
user for all damages, losses, and causes of action, if any, shall not exceed the total
purchase price paid for the product that gave rise to the claim.
SuperATV
will warranty only parts provided by SuperATV
®
problems with OEM housings, bearings, seals, or other manufacturers' products will
not be covered by SuperATV
item was not installed properly, misused, or modified.
for Can-Am Maverick X3
and is not recommended. SuperATV's
®
to verify that they will work together.
®
has thousands of satisfied customers, user should be aware
®
urges operators and occupants
®
products, user agrees that should damages
®
will not be held responsible for loss of time, use, labor fees,
®
, nor any 3rd party, will not be held
®
®
. SuperATV
parts and products are not warrantied if
®
®
IN-HWS-CA-X3 10/12/2016
Seal
®
. The total liability of seller to
. Any damage or
®

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Half Windshield and is the answer not in the manual?

Questions and answers

Summary of Contents for SuperATV Half Windshield

  • Page 1 Half Windshield: for Can-Am Maverick X3 2753 Michigan Road • Madison, Indiana 47250 • 812-574-7777 SuperATV does not recommend keeping Windshield installed while transporting on an open air trailer. Use hand tools only when assembling. 2x - Clamp Do not use power tools.
  • Page 2 - Install Seal to Windshield as shown. - Before installing Seal, soak in hot water to increase flexibility. Windshield Seal Bulb portion of Seal to always face towards vehicle 2 each Remove Clamp hardware; set aside. M6 x 20mm Sealing Washer Rubber must face Windshield when installing.
  • Page 3 - Place Windhield onto Cage and secure Clamps with included hardware. - Tighten hardware completely (passenger side) included with Clamps Windshield Cleaning: - Do not use window cleaning fluids (Windex, 409, etc) or any solvents (gasoline, denatured alcohol, acetone, etc). - Never use abrasive cleaners, abrasive pads, or gritty cloths.

Table of Contents