Advertisement
2753 Michigan Road • Madison, Indiana 47250 • 812-574-7777
4x
Grommet
4x
M6 Washer
54x
M6-1.0 Nylock Nut
54x
54x
Read instructions and view illustrations before beginning.
Need help with your installation?
sales@superatv.com
1-812-574-7777
Thank You
© 2016 SuperATV.com. All Rights Reserved.
M6 Sealing Washer
M6-1.0 x 25mm Lg. BHCS
Gasket
(kit contents continue on following pages)
www.superatv.com
8:00am - 9:00pm EST M-Th
8:00am - 7:00pm EST Friday
9:00am - 2:00pm EST Saturday
For Choosing
INSTALLATION INSTRUCTIONS
Tinted Roof:
Use hand tools only when assembling.
Do not use power tools.
4x - 1.50" Clamp
(disassemble)
Flat Seal
Liability Statement
SuperATV's
products are designed to best fit user's ATV/UTV under stock
®
conditions. Adding, modifying, or fabricating any factory or aftermarket parts will
void any warranty provided by SuperATV
products could interfere with other aftermarket accessories. If user has aftermarket
products on machine, contact SuperATV
Although SuperATV
®
that installing lift kits, long travel, or suspension kits, tires, etc. will change the ride
of machine and may increase maintenance and part wear. Operating any off-road
machine while, or after, consuming alcohol and/or drugs increases risk of bodily
harm or death. No warranty or representation is made as to this product's ability to
protect user from severe injury or death. SuperATV
to wear a helmet and appropriate riding gear at all times.
By purchasing and installing SuperATV
occur, SuperATV
will not be held responsible for loss of time, use, labor fees,
®
replacement parts, or freight charges. SuperATV
responsible for any direct, indirect, incidental, special, or consequential damages
that result from any product purchased from SuperATV
user for all damages, losses, and causes of action, if any, shall not exceed the total
purchase price paid for the product that gave rise to the claim.
SuperATV
will warranty only parts provided by SuperATV
®
problems with OEM housings, bearings, seals, or other manufacturers' products will
not be covered by SuperATV
item was not installed properly, misused, or modified.
for Yamaha Wolverine
4x - 2" Clamp
and is not recommended. SuperATV's
®
to verify that they will work together.
®
has thousands of satisfied customers, user should be aware
urges operators and occupants
®
products, user agrees that should damages
®
, nor any 3rd party, will not be held
®
. The total liability of seller to
®
. SuperATV
parts and products are not warrantied if
®
®
IN-ROOF-Y-WV-002 5/10/2016
®
. Any damage or
®
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for SuperATV ROOF-Y-WV-002
Summary of Contents for SuperATV ROOF-Y-WV-002
- Page 1 No warranty or representation is made as to this product’s ability to 8:00am - 9:00pm EST M-Th protect user from severe injury or death. SuperATV urges operators and occupants ®...
- Page 2 (kit contents continued) Item Description Rear Panel Right Panel Left Panel Center Panel Right Rear Bracket Left Rear Bracket Right Bracket Left Bracket Right Front Bracket Left Front Bracket Rear Bracket IN-ROOF-Y-WV-002...
- Page 3 Reference Only; do not assemble at this time. (driver) (passenger) install Grommets into holes in Panels Tip: apply soapy water to Rubber Grommets. IN-ROOF-Y-WV-002...
- Page 4 - Install provided Flat Seal to highlighted sections shown on Brackets (E-L). Reference Item Description Flat Seal Right Rear Bracket Left Rear Bracket Right Bracket Left Bracket Right Front Bracket Left Front Bracket Rear Bracket IN-ROOF-Y-WV-002...
- Page 5 - Previously installed Flat Seals on Brackets must be against Roof Panels. - Repeat for opposite side. (passenger) Use hardware shown when installing. M6x 25mm 14 each Sealing Washer Rubber must face Roof Panels when installing Sealing Washer M6 Nut IN-ROOF-Y-WV-002...
- Page 6 Left Rear Bracket (F) with hardware shown. - Previously installed Flat Seals on Brackets must be against Roof Panels. (driver) Use hardware shown when installing. 22 each M6x 25mm (passenger) Rubber must face Roof Panels when installing Sealing Washer Sealing Washer M6 Nut IN-ROOF-Y-WV-002...
- Page 7 2" Clamp 1.50" Clamp (passenger) 1.50" Clamp 2" Clamp front (driver) Roof installation: - Secure Roof to Clamps with hardware shown. Previously removed hardware from 1.50" Clamps (passenger) 2" Clamp hardware x 4 M6x 25mm M6 Nut M6 Washer IN-ROOF-Y-WV-002...
- Page 8 1. Thouroughly rinse Roof to float off dirt and mud. 2. Using a soft cloth, or microfiber cloth, clean Roof with warm water and a gentle detergent. Baby shampoo or hand washing soap are recommended. 3. To prevent water spots, use a chamois to blot Windshield dry. IN-ROOF-Y-WV-002...
Need help?
Do you have a question about the ROOF-Y-WV-002 and is the answer not in the manual?
Questions and answers