Page 1
INSTALLATION INSTRUCTIONS Rear Windshield for Can-Am Defender 2753 Michigan Road • Madison, Indiana 47250 • 855-743-3427 SuperATV does not recommend keeping Windshield installed while transporting on an open air trailer. Windshield Small Bracket x 2 Seal Large Bracket x 5...
Page 2
Rubber must face Windshield when installing. - Install Seal around edge of Windshield. Start Seal here End Seal here if Start Seal here if SuperATV Roof SuperATV Roof is installed. is installed. Windshield Bulb portion of Seal to always Seal face towards vehicle Soak Seal in hot water before cutting or installing to increase flexibility.
Page 3
- Install Large Brackets to locations shown in Windshield. Loosely secure with hardware shown. (top) (driver side) (passenger side) M6 x 20mm M6 Nylock Nut Sealing Washer IN-RWS-CA-DEF...
Page 4
- Install to machines Cross Bar and secure Large Brackets with hardware shown. Large Bracket Cross Bar each Bracket M6 x 20mm Bracket Sealing Washer (passenger side) M6 Nylock Nut Cross Bar Large Bracket (driver side) IN-RWS-CA-DEF...
Page 5
- Install Small Brackets to top of Windshield with hardware shown. - Install remaining Large Brackets. - Tighten all hardware completely. qty (2) each Bracket Small Bracket Small Bracket M6 x 20mm Sealing Washer M6 Nylock Nut Large Bracket Large Bracket Windshield Cleaning: - Do not use window cleaning fluids (Windex, 409, etc) or any solvents (gasoline, denatured alcohol, acetone, etc).
Page 6
The Buyer is also responsible to obey all ® applicable federal, state, and local laws and ordinances when operating his/her vehicle while using this product, and the Buyer agrees to hold SuperATV harmless from any ®...
Need help?
Do you have a question about the Rear Windshield and is the answer not in the manual?
Questions and answers