SuperATV Half Windshield Installation Instructions

SuperATV Half Windshield Installation Instructions

For can-am maverick x3
Hide thumbs Also See for Half Windshield:

Advertisement

2753 Michigan Road • Madison, Indiana 47250 • 855-743-3427
SuperATV does not recommend keeping Windshield installed while transporting on an open air trailer.
2x - Clamp
4x
Need help with your installation?
sales@superatv.com
1-855-743-3427
®
© 2016 SuperATV.com
. All Rights Reserved.
Half Windshield:
Use hand tools only when assembling.
Do not use power tools.
M6 Sealing Washer
www.superatv.com
8:00am - 9:00pm EST M-Th
8:00am - 7:00pm EST Friday
9:00am - 2:00pm EST Saturday
INSTALLATION INSTRUCTIONS
Windshield
4x
M6-1.0 x 20mm Lg. BHCS
Read instructions and view illustrations before beginning.
for Can-Am Maverick X3
Seal
Thank You
For Choosing
IN-HWS-CA-X3 10/12/2016

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Half Windshield and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for SuperATV Half Windshield

  • Page 1 Half Windshield: for Can-Am Maverick X3 2753 Michigan Road • Madison, Indiana 47250 • 855-743-3427 SuperATV does not recommend keeping Windshield installed while transporting on an open air trailer. Use hand tools only when assembling. 2x - Clamp Do not use power tools.
  • Page 2 - Install Seal to Windshield as shown. - Before installing Seal, soak in hot water to increase flexibility. Windshield Seal Bulb portion of Seal to always face towards vehicle 2 each Remove Clamp hardware; set aside. M6 x 20mm Sealing Washer Rubber must face Windshield when installing. (passenger side) IN-HWS-CA-X3...
  • Page 3 - Place Windhield onto Cage and secure Clamps with included hardware. - Tighten hardware completely (passenger side) included with Clamps Windshield Cleaning: - Do not use window cleaning fluids (Windex, 409, etc) or any solvents (gasoline, denatured alcohol, acetone, etc). - Never use abrasive cleaners, abrasive pads, or gritty cloths. - Never use razor blades, scrapers, sqeegees, brushes, etc. 1. T houroughly rinse Windshield to float off dirt and mud. 2. U sing a soft cloth, or microfiber cloth, clean Windshield with warm water and a gentle detergent. Baby shampoo or hand washing soap are recommended. 3. T o prevent water spots, use a chamois to blot Windshield dry. IN-HWS-CA-X3...
  • Page 4 The Buyer is also responsible to obey all ® applicable federal, state, and local laws and ordinances when operating his/her vehicle while using this product, and the Buyer agrees to hold SuperATV harmless from any ®...

Table of Contents