Lift Motor Calibration
About
This procedure provides instruction to verify and calibrate the Lift Motor and Incline system.
The Lift Motor calibration should be verified any time the lift motor is replaced, the lift motor
fuse fails, or any incline system component is replaced.
Specifications
System Component
Lift Motor Calibration Distance*
Note: * Calibration distance is specified at incline level 0.
Procedure
Review entire procedure before starting.
1. Remove the Hood cover, see
2. Choose either the side or front access method to position the treadmill to access the lift
motor jackscrew. Go to the following selected side or front access procedures and
return to continue the calibration.
a. Side lift motor access method, go to
page 53,
1 1/8 in - 1 3/16 in (2.8 cm - 3.0 cm)
"Hood Cover Replacement" on
"Side lift platform assembly access" on
4 Adjustment Procedures
Lift Motor Calibration
Specification
page 60.
Page 49