Lift Motor Calibration; About; Specifications; Procedure - Precor Experience 700 line Series Service Manual

Lift Motor Calibration

About

This procedure provides instruction to verify and calibrate the Lift Motor and Incline system.
The Lift Motor calibration should be verified any time the lift motor is replaced, the lift motor
fuse fails, or any incline system component is replaced.

Specifications

System Component
Lift Motor Calibration Distance*
Note: * Calibration distance is specified at incline level 0.

Procedure

Review entire procedure before starting.
1. Remove the Hood cover, see
2. Choose either the side or front access method to position the treadmill to access the lift
motor jackscrew. Go to the following selected side or front access procedures and
return to continue the calibration.
a. Side lift motor access method, go to
page 65,
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
1 1/8 in - 1 3/16 in (2.8 cm - 3.0 cm)
"Hood Cover Replacement" on
"Side lift platform assembly access" on
5 Adjustment Procedures
Lift Motor Calibration
Specification
page 72.
Page 61