Table of Contents
Advertisement
Resistance check
In this step, the resistance of the hot wedge is checked and compared to the installed data. If the actual resistance de-
viates too much from the target resistance, the orange or red lamp will light up in the traffic light indicator. In this case,
please check whether the hot wedge has been mounted correctly, whether the right welding holder/welding width has
been selected, and whether the contact surfaces are free from contamination (see Chapter 8).
9.6.4
Positioning the Welding Wedge
Activating the clamp pressure
Before adjusting the position of the welding wedge, make sure there are no objects (e.g., mounted guides) within the
movement radius of the wedge holder in order to prevent any collisions when the wedge is swiveled in. Switch the
slider to "Auto" and carry out the next step by pressing the right-hand foot pedal.
35
Advertisement
Table of Contents
