Carefully Cut Open The Headrest Cover; Open The Headrest And Remove Filling And Other Items - Blaupunkt IVMS-5802 Operating And Installation Instructions

FITTING
Carefully cut open the headrest
cover
Use a knife with an adjustable cutting
depth to cut out the planned area.
Make the first cut inside the marked
area at a point about 0.5 cm from one
of the corners, then make a diago-
nal cut to a point about 0.5 cm from
the opposite corner.
Make a similar cut between the oth-
er two diagonally opposed corners.
18
Open the headrest and remove
filling and other items
Carefully lift the covering material
away from the cut area.
Adjust the cutting depth of the knife
to about 2.5 cm, and cut into the he-
adrest following a line about 0.5 cm
inside the marked edge.
Carefully lift the filling material at one
corner, and cut deeper into the ma-
terial with the knife.
Remove the filling material in small
pieces.
As you do this, lift one piece of the
filling material, and ensure that the
cut is being made to an even depth.
To remove other pieces, use a Dremel
saw or another suitable tool.
Insert the monitor to check that it will
fit into the cut area, and make ad-
justments if necessary.