Driver Installation For Windows Xp, Linux Kernel 2.4 Or Later; Hardware Setup - Transcend TS0MFLRD6E User Manual

Driver Installation for Windows XP, Linux Kernel 2.4 or Later

No driver is needed. Turn off the computer and refer to Hardware Setup below to install the
Internal 6-in-1 Card Reader into your PC.
1. Install the Internal 6-in-1 Card Reader into an available 3.5" drive bay.
2. Find the layout of the USB pin-header in the owner's manual of your motherboard.
3. If the layout of the USB pin-header is as shown below, it matches the default setting
of the USB connector.
1
If the layout of the USB pin-header is not as shown above, skip step 4 and go
directly to step 5.
4. Plug the USB connecter of the Internal 6-in-1 Card Reader into the USB
pin-header on the motherboard, with the red wire seated in pin 1 or pin 6. Hardware
setup is complete.

Hardware Setup

5
4
3
2
8
7
6
Pin 1: USB Power
Pin 2: USB -
Pin 3: USB +
Pin 4: GND
Pin 5: NC/USBOC
Pin 6: USB Power
10
Pin 7: USB -
9
Pin 8: USB +
Pin 9: GND
Pin 10: NC (No pin)
4