Table of Contents
Advertisement
6. Shutdown the computer and refer to the Hardware Setup below to set up the Internal
Multi-Card Reader.
Driver Installation for Windows Me, XP and Linux
No driver is needed. Turn off the computer and refer to Hardware Setup below to install the In-
ternal Multi-Card Reader into your PC.
1. Install the Internal Multi-Card Reader into an available 3.5" drive bay.
2. Find the layout of the USB pin-header in the owner's manual of your motherboard.
3. If the layout of the USB pin-header is as shown below, it matches the default setting of the USB
connector.
If the layout of the USB pin-header is not as shown above, skip step 4 and go directly to
step 5.
4. Plug the USB connecter of the Internal Multi-Card Reader into the USB pin-header on the
motherboard, with the red wire seated in pin 1 or pin 6. The hardware setup is complete.
Hardware Setup
5
4
3
2
1
8
7
6
Pin 1: USB Power
Pin 2: USB -
Pin 3: USB +
Pin 4: GND
Pin 5: NC/USBOC
Pin 6: USB Power
10
Pin 7: USB -
9
Pin 8: USB +
Pin 9: GND
Pin 10: NC (No pin)
4
Advertisement
Table of Contents
