Driver Installation For Mac ™ Os 9.X; Driver Installation For Mac ™ Os 10.1.2, Or Later; Driver Installation For Linux ™ Kernel 2.4, Or Later - Transcend m2 Quick Instruction Manual

Driver Installation for Mac
1.
Put the Driver CD into the CD-ROM drive and run the Install program located in the Mac folder on the
Driver CD. Follow the on-screen instructions to complete the driver installation.
2.
Plug the Multi-Card Reader into an available USB port.
3.
Insert a memory card into the Multi-Card Reader. A disk icon will appear on the desktop. After the icon
appears you can use the memory card as if it were a Hard Disk on your Mac .
Driver Installation for Mac
No drivers are required. Plug your Multi-Card Reader into an available USB port, insert a compatible
Memory Card and your Mac
Driver Installation for Linux
Transcend's Multi-Card Reader does not require a device driver for Linux Kernel 2.4 or later. You may
connect the Reader directly to a USB port on you computer using the supplied cable. Please follow the
below procedures to mount and use the device:
1. Add the following two commands to /etc/modules.conf
2. Plug the Multi-Card Reader into an available USB port using the supplied cable and restart the
computer. Your computer automatically detects the Multi-Card Reader.
3. Create a directory for the Multi-Card Reader.
Example: mkdir /mnt/CardReader
4. Mount the Multi-Card Reader.
Example: mount –a –t msdos /dev/sda1 /mnt/CardReader
™
OS 9.x
Figure 8. Mac Driver Installation
™
OS 10.1.2, or Later
™
will automatically detect it.
™
Kernel 2.4, or Later
options scsi_mod max_scsi_luns=2
TS-RDM1
below usb-storage sd_mod
options scsi_mod max_scsi_luns=5
TS-RDM2
below usb-storage sd_mod
8