Advertisement
Maintenance
Note! When using for the first time or when
starting up after a long period of disuse, a
small amount of smoke and a slight odour
may occur temporarily, which is completely
normal.
The power supply to the unit must be
disconnected during all service, repair and
maintenance work.
The unit has no moving parts so the
maintenance requirement is small, but it
must be kept clean and free from dust and
dirt. If the reflector is not clean the thermal
radiation from the unit will decrease and the
heater will become hotter. A large amount of
dirt can cause overheating.
The surface of the reflector is sensitive and
must be cleaned with care. If the reflector
is dirty it must be cleaned or replaced by a
specialist.
Assembly and disassembly of the front grid
ICW/ICS/ICB
Safety
• During operation the surfaces of the unit
are hot!
• The unit must not be fully or partially
covered with inflammable materials, as
overheating can result in a fire risk!
• This product is not designed to be used
by children or persons with reduced
physical or mental ability or a lack
of experience and knowledge, unless
instruction regarding the product's
use has been given by a person with
responsibility for their safety or that this
person supervises operation. Children
must be kept under supervision to ensure
they do not play with the product.
• The heater is equipped with a protective
grille to prevent contact or to prevent
large objects from touching the hot lamp.
The unit must not be used without this
protective grille.
• Ensure that there are no inflammable
materials gathered on or close to the
heater.
• The free space to the inflammable
material in the direction of radiation
must be at least 1,5 meter.
• Do not place the heater directly under the
electrical socket.
• The cable and plug must not be exposed
to the heat from this appliance.
• Do not use timer that switches the heater
on automatically since a fire risk exists
if the heater is covered or positioned
incorrectly.
GB
21
Advertisement
