Subscribe to Our Youtube Channel
Related Manuals for motogadget Motoscope Tiny
Summary of Contents for motogadget Motoscope Tiny
- Page 1 Operating and installation guide - motoscope tiny - Suchen Sie die deutsche Bedienungsanleitung? Besuchen Sie: www.motogadget.de/de/mst_files.html...
- Page 2 Thank you very much for purchasing a high quality product by motogadget. Please read the following information and recommendations thoroughly and follow these instructions during installation and use of the instrument. No liability is assumed by motogadget for damage or defects resulting from negligence or failure to follow the operating and installation guide.
-
Page 3: Exclusion Of Liability
2.1 Duty of registration The motoscope tiny does not have to be registered if used in addition to a registered speedometer. If it is used as a single instrument without any other speedometer in areas of public traffic, the use of the instrument must conform to the laws of the country concerned. -
Page 4: Quick Start
4.2 Required materials for installing and connecting the instrument Since the motoscope tiny is suitable for a variety of vehicles, additional materials might be neces- sary in order to mount the instrument to an individual vehicle. Such materials can include: •... -
Page 5: General Safety Instructions
• Make sure that your vehicle is equipped with interference suppressing spark plugs and connector cables! Use of the motoscope tiny with non-suppressed ignition systems can lead to serious damage to the device! 7 Installation of the instrument To ensure correct fastening two metric fastening screws must be used (M3). In order to avoid distortions of the threaded bores, the fastening bolts must be screwed into the instrument housing to a minimum depth of 3 mm and a maximum depth of 5 mm. - Page 6 8.2 Battery and voltage supply The motoscope tiny require supply voltage from 9V to 15V. Operating the instrument without a vehicle battery is not possible. Please ensure that the polarity of the voltage supply is correct. ATTENTION! THE MINIMAL SUPPLY CABLE WIDTH IS 0,75MM².
- Page 7 2 Nm. For secure mounting we recommend to use screw adhesive (medium strength). Subsequently, connect one cable of the speedometer sensor with +12 V ("switched plus") and the other one with the orange cable of the motoscope tiny. Polarity is not relevant. ATTENTION!
- Page 8 12.2 Menu 2 – Odometer setup (SET ODO) If you like to take the vehicles milage form the old speedometer to the motoscope tiny you can setup this value. A short push button operation (one indicator light is illuminated) increases the chosen digit.
-
Page 9: Safety Instructions
13 Safety instructions The motoscope tiny provides a lot of information at one time. Users consequently require a certain "training" period in order to recognise all the given information quickly and correctly. Please do not distract yourself by watching the instrument in public traffic. - Page 10 - Make sure again there is no connection failure. In doubt use a different voltage source to recheck. - Not prepaid shipments will be rejected. - The Shipment to motogadget is carried out by your own risk - you are responsible for a sufficient insurance.
- Page 11 15.2 Joining of two turn signal indicator lights motoscope tiny yellow cable plus from plus from indicator control left indicator control right diode 1A observe polarity 15.3 General overview of operation Normal Operation Setup Menue minute count up Set hour...
- Page 12 15.4 Table of tire circumferences Zoll Reifendimension Abrollumfang für Zoll Reifendimension Abrollumfang für Inch Tyre Size ABE / Gutachten Inch Tyre Size ABE / Gutachten 100/90 16 1770 90/90 - 18 51 H TL 1869 110/90 16 1824 100/90 - 18 56 H 1924 120/80 16 1806...
Need help?
Do you have a question about the Motoscope Tiny and is the answer not in the manual?
Questions and answers