Care And Maintenance - Porter CENTER-STRUT Assembly, Installation & Maintenance Instructions

A. For manual height adjusters, semi-annually lubricate the entire threaded rod assembly and upper thrust roller bearing with any
high quality multi-purpose type grease.
B. Periodically inspect height adjustment unit and support system for loose or defective parts – tighten or replace immediately as
required.
C. Periodically (at least annually, depending on usage) lubricate the two plated inside tubes with an aerosol dry lubricant, such as
Sprayon™ #S00708 T.F.E. DRY LUBE. Sprayon™ #S00708 T.F.E. DRY LUBE is available from your local Porter dealer or
from Porter Athletic Equipment Company, in a 10 oz. aerosol can (Porter part number MISC00243000). Run height adjuster up
and down (10' to 8') several times. NOTE – protect the floor with a drop cloth to prevent a slippery build-up on the gymnasium
floor.

CARE AND MAINTENANCE

Lubricate threaded rod and upper
thrust roller bearing per Step A above
(manual operation only)
Lubricate both inside slide
TYPICAL FAN
BOARD SHOWN
THIS WARNING IS GIVEN IN COMPLIANCE
WITH CALIFORNIA'S PROPOSITION 65:
WARNING: This product can expose you to Titanium Dioxide,
which is known to the State of California to cause cancer.
This product contains chemicals known to the
For more information go to www.p65warnings.ca.gov.
State of California to cause cancer, birth defects
or other reproductive harm.
Porter Athletic Equipment Company
601 Mercury Drive, Champaign, IL U.S.A., 61822
Toll Free: (888) 277-7778 Phone: (217) 367-8438 Fax: (217) 239-2255
SAVE THESE INSTRUCTIONS FOR FUTURE USE
tubes per Step C above
TYPICAL
RECTANGULAR
BOARD SHOWN
WARNING
www.porterathletic.com
17
E