Lifetime 90056 Owner's Manual page 18

TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
9/16"
SEC
Attach the Bottom Brace (BLU) to the Rear Bottom Legs (BMA) with the
2.3
hardware shown.
perpindicular to the ground as pictured.
until instructed to tighten all hardware later in the assembly.
BMM
Note: If it becomes difficult to line up the bolts with their appropriate holes, loosen the
!
hardware until it is fingertight, then tighten all hardware at the end of the assembly.
BMM (x2)
Make sure the hole in the center of the Bottom Brace is
BLU
Bottom Brace Alignment
18
(x2)
Only fingertighten the 3/8" Cap Nuts
BMM
BMA
Do not overtighten the Cap Nut.
BMA