Table of Contents
Advertisement
MAINTENANCE
Important: Use only
sudden and immediate loss of load. We recommend Mobil DTE 13M or equivalent.
Adding oil
1. With saddle fully lowered set jack in its upright, level position. Locate and remove vent screw.
will not raise to its advertised maximum height. Reinstall the vent screw.
Changing oil
2. Fill with oil until
Note:
Lubrication
A periodic coating of light lubricating oil to pivot points, axles and hinges will help to prevent rust and assure that
wheels, casters and pump assemblies move freely.
Cleaning
Periodically check the pump piston and ram for signs of rust/corrosion. Clean as needed and wipe with oily cloth.
Note: Never use sandpaper or abrasive material on these surfaces!
Storage
When not in use, store the jack with saddle fully lowered. This will help prevent rust and corrosion to those critical
surfaces.
TROUBLESHOOTING
Symptom
Jack will not lift load
Jack will lift, but not maintain
pressure
Jack will not lower after unloading
Poor lift performance
Will not lift to full extension
Possible Causes
Release valve not tightly closed
5
Never
.
.
. Reinstall vent screw.
Corrective Action
Ensure release valve tightly closed
Technical Service (888) 332-6419
Technical Service (888) 332-6419
Advertisement
Table of Contents
Need help?
Do you have a question about the SwiftLift ATD-7325 and is the answer not in the manual?