Bego Nautilus CC plus Manual page 65

English ⋅ Nautilus
6. Insert the mould as quickly as possible after
the preheating process has been completed.
WARNING
Risk of burns!
Use mould tongs!
7. Close the mould door.
The next display is shown when the mould
door is closed.
WARNING
Never look into the melt without
protective glass and protective
eyewear!
8. Confirm the melting process by pressing the
"OK" button or skip it by pressing the "Abort"
button.
NOTICE
If no video image is shown on the screen, the
message "Temperature too low" will appear. As
soon as the camera detects an image, it will be
transmitted to the screen!
®
The NAUTILUS T shows a video of the pro-
cess on the screen.
9. Enter the additional heating time for melting
(see the table on page 35) using the "+" and "-"
buttons.
The timer counts down the entered seconds
and thus determines the time to cast.
®
T
en
65