Bego Nautilus CC plus Manual page 17

Electricity
Pyrometer
English ⋅ Nautilus
Prior to connecting the device to the power supply,
check and make sure that the specifications on the
rating plate correspond to the power supply
network. Consult an electrician in case of uncer-
tainty.
The device is subject to protection class I and must
only be connected to properly grounded and fused
power sources.
Recommendation: Always operate the device in a
single power circuit (min. 16A fuse).
Installation in countries without 230 V network:
The electrical installation must only be carried out by
a qualified electrician!
Use the transformer (REF 17800) for connection.
1. Adapt the power connection of the transformer
to local circumstances.
2. Insert the Nautilus
former.
The device is subject to the provisions of class of
protection I and may only be connected to properly
grounded power sources.
Remove the cover of the precision optics before
initial commissioning (NAUTILUS
®
CC plus ⋅ Nautilus
®
-power plug into the trans-
®
®
T
en
CC plus only)
17