Advertisement
SERVICE MANUAL
The particular characteristic of this MODEL is the 7° front frame taper.
As it is visible from the picture, the longer the footplate distance DP, the
narrower the room X between the two frames at footplate's level.
According to that, when adjusting the footplate distance, it is necessary to
keep the 7° taper and increase or decrease the room X.
After adjustment, the forks have to be perpendicular to the ground. That will
tell you keep the 7° frame taper.
All footplates available for this model allows for such adjustment.
HEIGHT ADJUSTMENT EVERY 1.5cm
Usually, it is granted an adjustment of +1.5 cm and - 1.5 cm with respect to
the footplate distance requested.
Screw off the bolt A of both side of the frame.
Slide the tubes to the necessary height.
Make sure the height of the two sides is the same.
Insert the bolt A paying attention to fitting it with no effort into the threaded
hole B on the rear side of the support C.
The footplate tube's holes and the hole of the support B must be aligned.
Finally, tighten the bolt A on both sides of the frame.
Do not force screwing the bolt, you may damage the thread of the hole B.
Should that occur, you can remedy by pass the threaded hole with a M5 tap
starting from the rear side of the support. If the thread is too damaged to be
repaired, you can pass the hole with a 5 mm drill bit and fix the tube with a
longer bolt, washer and nut.
You can not change the support C.
After adjustment, check that between the lower side of the footplate and the
ground there is at least 2 cm and that there is no interference between foot-
plate and casters.
REHATEAM s.r.l.—vicolo Negrelli 5—31040 Castagnole di Paese TV - www.rehateamprogeo.com
FOOTPLATE DISTANCE
DP
2.5°
(A)
C
FRONT
Service Manual NOIR 2.0 8
2.5°
X1
X2
X3
90°
A
A
C
C
B
REAR
Advertisement
