Advertisement
SERVICE MANUAL
For this model, the frame is individually manufactured and welded to measure, there-
fore, the front height cannot be modified.
In most cases, however, it is possible to change the caster with a smaller or larger one
as long as the front height does not change; otherwise, the fork angle loses its perpen-
dicularity.
The holes on the forks are ½" away from one-another, therefore, if you change the
caster with one that is 1" bigger or smaller, you will have to change its fixing position to
keep the original front height.
The position of the caster on the fork (requested on the order form) is determined
while designing the frame.
As long as it is possible, the design allows fo assembling another size of caster
(smaller or bigger) apart from the requested one.
The three drawings aside show the most common combinations and you should notice
that the height from the ground remains the same because of the fixing changes.
If such principle is neglected, the fork angle will no longer be perpendicular to the
ground.
To change the caster, screw off the bolt V while holding the other.
Remove the axle P.
Position the caster to another hole, insert the axle and fix the bolt V holding the one on
the other side.
Pay attention to the spacers between caster and fork.
V
It is advisable to spread a
drop of mild lock thread
glue on the bolts V.
REHATEAM s.r.l.—vicolo Negrelli 5—31040 Castagnole di Paese TV - www.rehateamprogeo.com
CASTER CHANGE
P
V
height
Holes interval – 12,7 mm (1/2 ")
Sport – 2 holes – h. 100
4"
3"
4"
3"
5"
4"
Service Manual NOIR 2.0 4
Fork
H.
4"
3"
4"
3"
5"
4"
Advertisement
