Advertisement
SERVICE MANUAL
It is possible to make the seat width larger by maximum 10 mm each side, by
modifying the side guard fixing.
Remove the bolt V1 and it corresponding nut.
The brake and its support remains fixed to the side guard.
Note that a 3 mm spacer A is already present.
You have to replace the bolt V1 with 5 or 10 mm longer ones according to
the extent of the enlargement.
Insert the longer bolt through the holes of side guard, put 1 or 2 spacers B in
addition to the spacer A, let the bolt pass through the frame and fix all the
parts together.
DO NON OVERTIGHTEN, the tube in carbon fibre may crack.
When you feel the nut starts to tighten, the torque is enough to make the side guard firm.
V1
C
Remove the bolt V2 and the nut C, then, turn the side guard up. This way, you will free the backrest plate, too.
Note that a 3 mm spacer A is already present.
You have to replace the bolt V2 with 5 or 10 mm longer ones according to the extent of the enlargement.
Insert the longer bolt through the holes of side guard, put 1 or 2 spacers B in addition to the spacer A and let the bolt through the frame and
through the hole of the backrest plate.
Make sure to put all washers of the backrest plate correctly (you can use as reference the other side that has not been touched).
Now. fix bolt and nut V2 C.
Now, it is necessary to check the gap between side guard and rear wheel and decide whether or not, to add spacers on the wheel
In such case, remove the wheel receiver and add 3 and/or 6 mm spacers.
Finally, spread some mild thread lock glue on the receiver thread and tighten the receiver.
The maximum overall thickness of the spacer must not be more than 9 mm.
If the receiver results too hard to unscrew, DO NOT INSIST AND DO NOT HEAT THE PARTS, the inner buckle (in which the re-
ceiver is screwed) that is glued to the carbon tube may detach.
ating) to the head of the receiver
Advice: before removing the receiver, it is useful, as a try, put the spacer on the axle of the wheel and put it on.
This way, you will immediately see what spacer you need.
REHATEAM s.r.l.—vicolo Negrelli 5—31040 Castagnole di Paese TV - www.rehateamprogeo.com
SEAT WIDTH ENLARGEMENT
V2
A B
V2
and try to unscrew it. If that is not enough, Contact Rehateam s.r.l..
A
A
You may try to give one or two hit with a hammer (without exagger-
A
V1
B
receiver.
Service Manual NOIR 2.0 13
Advertisement
