Table of Contents
Advertisement
Switch Settings
Installation
Operation
xii
Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.com
The RTB provides the configuration switch SW3 which functions are
reserved. The switches have to be set to OFF to avoid damage to attached
PMC modules. Therefore, never change the settings of SW3.
Electrostatic discharge and incorrect board installation and removal can
damage circuits or shorten their life. Therefore:
• Before installing or removing the board, read the "Action Plan" sec-
tion on page 1-6.
• Before touching boards or electronic components, make sure that you
are working in an ESD-safe environment.
• When plugging the board in or removing it, do not press on the front
panel but use the handles.
• Before installing or removing an additional device or module, read
the respective documentation.
• Make sure that the board is connected to the CompactPCI backplane
via all assembled connectors and that power is available on all power
pins.
• Only install and use the ACC/RTB-735R2/736R2 with CPU boards
especially designed for it. Otherwise, both the CPU board and the
RTB may be destroyed.
• Make sure to use the backplane's rear slot position only.
While operating the board ensure that the environmental and power
requirements are met.
When operating the board in areas of electromagnetic radiation ensure
that the board is bolted on the CompactPCI system and the system is
shielded by enclosure.
Make sure that contacts and cables of the board cannot be touched while
the board is operating.
Do not operate the product outside the specified environmental limits.
High humidity and condensation may cause short circuits. Make sure the
product is completely dry and there is no moisture on any surface before
applying power. Do not operate the product below 0°C.
ACC/RTB-735R2/736R2
Advertisement
Table of Contents
