Silvercrest SFW 350 D3 Operating Instructions Manual page 35

Assembling the kubbe attachment
Unfold the fold-out side . There you will find the step-by-step illustrations for as-
sembling the appliance .
1) Remove the meat grinder casing 6 as described under "Assembling the
meat grinder" .
2) Disassemble any attachments that might be fitted and clean the meat grinder
casing 6 .
NOTICE
► To use the kubbe attachment i, neither the cross blade e with the spring w,
nor a cutting or sausage disc r/u are required! Remove these from the
meat grinder casing 6 if necessary .
3) Coat all metal parts with cooking oil .
4) Insert the two plastic parts of the kubbe attachment i so that the fixings on
the bottom kubbe attachment i ring are located in the openings in the meat
grinder casing 6 .
5) When everything has been attached correctly, screw the ring clamp t back
on hand-tight .
6) Assemble the meat grinder casing 6 as described under "Assembling the
meat grinder" .
Assembling the biscuit attachments
Unfold the fold-out side . There you will find the step-by-step illustrations for as-
sembling the appliance .
1) Remove the meat grinder casing 6 as described under "Assembling the
meat grinder" .
2) Disassemble any attachments that might be fitted and clean the meat grinder
casing 6 .
NOTICE
► To use the biscuit attachment 1, neither the cross blade e with the spring w,
nor a cutting or sausage disc r/u are required! Remove these from the
meat grinder casing 6 if necessary .
3) Coat all metal parts with cooking oil .
4) Pull the pattern strips 1 away from the front of the biscuit attachment 1 .
5) First place the plastic disc and then the metal disc of the biscuit attachment 1
into the meat grinder casing 6 (see fold-out side) . Insert the biscuit attach-
ment 1 . so that the fixings on the biscuit attachment 1 . are located in the
openings in the meat grinder casing 6 .
6) After everything has been correctly assembled, screw the ring clamp t
back on hand-tight .
■ 32 │ GB │ IE
SFW 350 D3