Aaeon EMB-Q170B Manual page 24

6. Chassis intrusion header (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch.
Connect one end of the chassis intrusion sensor or switch cable to this
connector. The chassis intrusion sensor or switch sends a high-level signal to
this connector when a chassis component is removed or replaced. The signal
is then generated as a chassis intrusion event.
By default, the pin labeled "Chassis Signal" and "Ground" are shorted with
a jumper cap. Remove the jumper caps only when you intend to use the
chassis intrusion detection feature.
EMB-Q170B Chassis intrusion connector
7. Intel ME Jumper (3-pin DIS_ME)
®
This jumper allows you to force the Intel
to recovery mode when ME becomes corrupted.
EMB-Q170B Intel
2-16
CHASSIS
Intrudor
Intrudor
No Intrudor
EMB-Q170B
1
ME Enable
(Default)
EMB-Q170B
ME jumper
®
PIN1
Management Engine (ME) to boot
®
DIS_ME
2 2 3
ME Disable
EMB-Q170B