Setting The Speed-Dependent Volume Increase (Auto Snd) - Blaupunkt QUEENS MP56 7 646 583 310 Operating Instructions Manual

Changing basic settings in the settings menu
Selecting a sound presetting
( PRESET)
This menu item allows you to se-
lect one of the following sound
presets: VOCAL, DISCO, ROCK,
JAZZ or CLASSIC.
➔
Press the softkey located next
to the desired sound preset.
The selected sound preset is
highlighted and shown on the
A
main line .
➔
To turn the equalizer off, press
:
the softkey
OFF") instead.
Setting the speed-dependent
volume increase ( AUTO SND)
When you are driving faster, the
device can automatically increase
the volume to compensate for the
driving noise. In order for this to
work, the speedometer signal
must be connected as described
in the installation instructions.
You can adjust this volume in-
crease from 0 (no increase) to 5
(maximum increase).
➔
Repeatedly press the softkey
9
(next to "AUTO SND").
The current speed-dependent
volume increase is shown on
the main line
110
(next to "P-EQ
A
.
Note:
If no increase is set, the main
A
line shows "AUTO SND OFF".
➔
On the rocker switch
or to raise the volume in-
crease.
➔
On the rocker switch
or to lower the volume in-
crease.
Setting the bass increase ( XBASS)
XBASS is a bass increase at low
volume. This bass increase can be
set in increments from 0 (no in-
crease) to 6 (maximum increase)
for the following frequencies:
32 Hz, 40 Hz, 50 Hz, 63 Hz, or 80 Hz.
➔
Press the softkey
"XBASS").
The "XBASS" menu item is
fl ashing. The frequency (Hz)
and bass increase (GAIN) are
shown on the main line
➔
On the rocker switch
or to select the desired fre-
quency.
➔
On the rocker switch
or to set the desired bass
increase.
Confi guring the preamplifi er out-
put for the subwoofer ( SUBOUT)
If you want to use an additional
subwoofer, it can be adjusted to
the other loudspeakers.
3
, press
3
, press
;
(next to
A
.
3
, press
3
, press