Panasonic PAW-160MAH2L Installation Instructions Manual page 88

Control
value is shown on the PV display and the currently set temperature value is shown on the SV
display.
Changing the set temperature value
To change the set temperature value, perform the following steps:
1. During operation, press the
The SV display is blinking.
2. Change the set value as required, using the
The SV display shows the desired temperature value.
3. Confi rm the setting by pressing the
The SV display permanently shows the new set value.
i
Important
The set temperature value, which is adjustable by the above procedure, can be used in diff e-
rent ways and with diff erent functions depending on how the thermostat is used in the individual
application.
For further information see "7.2.3 Initial Settings".
86
Control voltage switched on
Normal view
button.
1 x briefl y
1 x briefl y
1. Software version view (factory setting)
2. Input specifi cation view (factory setting)
3. Measuring range (factory setting)
PV = lower limit
SV = upper limit
4. The two displays fi nally change to normal view:
PV = currently measured temperature (process value)
SV = currently set temperature value
, and
button.
buttons.