Panasonic PAW-160MAH2L Installation Instructions Manual page 62

Electrical Wiring
Section F
Connections
Terminal layout – PAW-T10 (for advanced and light versions only)
PAW-T10 PCB
Connections
i
Important
For details about the connection and functions of the PAW-T10 PCB, please refer to the separa-
te installation instructions for PAW-T10.
60
No. Name In / Out Allocation
M2-6
10 I GRY
(FREE)
9 M2-5 I ORG
8 M2-4 I WHT
7 M2-3 I RED
6 M2-2 I/O RED
5 M2-1 O WHT
E2-2 /
4 I No polarity
E3-2
E2-1 /
3 I No polarity
E3-1
2 E1-2 I No polarity
1 E1-1 I No polarity
No. In / Out Allocation
1 I (1) Potential for I (2)
2 I (2) ON / OFF
3 I (3) Lock RC
4 I (4) Potential for I (3)
5 O (5) Operation Signal NC
6 O (6) Operation Signal NO
7 O (7) Potential for O (5) and O (6)
8 O (8) Alarm Signal NC
9 O (9) Alarm Signal NO
10 O (10) Potential for O (8) and O (9)
Function Comments
Advanced & Medium: Activation of
Remove bridge for use of demand
demand control
control (if bridge is intact and in place,
Advanced & Medium: Activation of
temperature setpoint control is active)
demand control
Advanced & Medium: Analogue input Advanced & Medium: Negative poten-
Demand tial (–10 V DC) for demand control
Advanced & Medium: Analogue input Advanced & Medium: Analogue input
Demand (+10 V DC) for demand control
Advanced only: Internal potential
Advanced only: Analogue output (+10 V DC) from TR-16/TR-16e via
bridge
Advanced only: Internal potential
Advanced only: Analogue output 10 V DC from TR-16/TR-16e via
bridge
Sensor E2 / TH3 (PACi) or
Sensor E3 / TH4 (ECOi), respectively
Sensor E1 / TH2
Function Comments
External Start / Stop
Lock (Contact closed) or
Unlock (Contact open) remote control-
ler, respectively
External Potential:
Operation Signal as normally open or
max. 250 V AC / 5 A
normally closed contact
External Potential:
Alarm Signal as normally open or
max. 250 V AC / 5 A
normally closed contact