Panasonic PAW-160MAH2L Installation Instructions Manual page 44

Installation
!
NOTICE
Signal errors through noise from live power supply cords
Power supply cords can generate noise, which may cause signal errors, if they are run in close
vicinity to any low-voltage control wiring.
► Keep 230 V AC power supply wiring apart from the low-voltage control wiring for sen-
sors etc.
► Route 230 V AC power supply wiring through diff erent cable glands than the low-volta-
ge control wiring.
5. Insert the wiring preferably from below the enclosure through the screwed cable glands and
connect the wires to each of the 6 connectors as required.
After having fi nished wiring and applying power to the AHU Kit, auto-addressing can be per-
formed and the parameters of the thermostat (advanced version only) can be set.
i
Important
Please note that the connectors can be plugged out for easy installation. As connectors A and
D are intended for connecting the 230 V AC power supply wiring, they have special blind ports,
which prevent them from being plugged back into the low-voltage connectors B, C, E or F.
6. Place the cover back on the enclosure and fi x it with the 4 screws at the corners.
42