Graco Matrix PAC 247436 Manual page 5

Registering the PAC
(h)
(f)
(g)
(e)
F . 2
IG
1. Press and hold NET ID button (c) (F
ment NET ID to match desired Network ID.
2. Press and hold TRANS ID button (d) (F
increment TRANS ID to match desired Transceiver
ID.
3. Once the correct NET ID and TRANS ID are flash-
ing, to register the PAC with Matrix
press and hold both buttons (c) and (d) for a few
seconds until you notice the display:
• momentarily go black,
• then flicker,
• and then the numbers reappear steady.
• The flicker is a signal that the PAC has suc-
cessfully been registered with Matrix.
• Numbers will flash until PAC unit is successfully
registered with Matrix PC software.
312417F
Mode Configuration
1. Press and hold MODE button (e) (F
(c)
(d)
ti11964a
. 2) to incre-
IG
. 2) to
IG
™
PC Software,
Matrix or Override mode.
The LED next to selected mode will illuminate to
indicate which mode, OVERRIDE (f) or MATRIX (g)
is selected.
• In the MATRIX (preferred) (g) (F
pump will not operate unless it receives an
authorization code from Matrix software. Unau-
thorized dispenses are not allowed in this mode.
• The OVERRIDE mode (f) (F
the pump so the pump can be used without
authorization through Matrix. VALVE ON LED
(h) will indicate the solenoid valve is acti-
vated/deactivated.
Registering the PAC
. 2) to select
IG
. 2) mode, the
IG
. 2), turns on air to
IG
5