Ip5122-Sdc Programming - Toshiba Strata CIX IP5000-UG-VC User Manual

IP5122-SDC

IP5122-SDC Programming

IP5122-SDC Programming
Important!
The programming, shown below, must be done at your IP5122-SDC telephone. This
procedure shows only the programming unique to the IP5122-SDC. For all other
programming functions refer to the DKT/IPT Administrator Guide.
 To place your telephone in Programming Mode
1. Press
"SELECT="
2. Press
Your phone will not ring if it receives a call while in Programming Mode.
Note
 Place the phone into programming mode then set the following:
Typically, FB20 ~ FB09 will be left at factory default. However, if necessary,
Note
use the Scroll key (SK3) to access FB11 through FB20.
1. Press FB01 – ACO Button position. Enter the button position, then press Hold.
Go to the next Step or, if you are finished programming, go to
Enter 1 ~ 10 (Default = 10, FB10)
2. Press FB02 – ACO privacy (Privacy override is not available). Enter the ACO
privacy value, then press Hold. Go to the next Step or, if you are finished
programming, go to
1 for No privacy (default) – other IP5122-SDC with the same ACO can access the
CO line while it is in use.
2 for Privacy – other IP5122-SDC with the same ACO cannot access the CO line
while it is in use.
3. Press FB03 – ACO Ringing assignment. Enter the ring assignment then press
Hold. Go to the next Step or, if you are finished programming, go to
2 = Ring (Default)
1 = No ring
96
The IP5122-SDC must be programmed, using eManager, as a 20 button
station (Prog. 204). Feature Button 11 (FB11) must be programmed as
a Release button. When the ACO button is pressed the IP5122-SDC
sends Hold and FB11 (Release) to the CIX system.
FB12 ~ FB20 must be blank.
The feature button used as the ACO must be blank (no assignment) in
the CIX data base (Prog. 205).
3 6 9 Hold
+ + + simultaneously. The LCD displays "PROGRAM MODE" and
4 Hold
, then press .
Step 9.
Strata CIX IP5000-series Telephone UG
Step 9.
Step 9.
07/09