Ricoh FT 4015 Service Manual page 88

20 December 1996
4. Pass the connector [B] through the opening [C], and mount the
anit-condensation heater [D] as shown (1 screw).
5. Connect the red two-pin connector [E] at the rear of the copier to the
heater's connector [B] (red).
6. Make sure that scanner drive belt and mirrors do not touch the heater
harness while they are functioning.
NOTE: Tell the customer that even when the copier main switch is turned
off, the copier power cord should be plugged in. Otherwise, the
optics anti-condensation heater will not function.
3-17
OTHERS