Ricoh FT 4015 Service Manual page 111

20 December 1996
Mode No.
Factory
83 Potential
Adjustment
Total Copy
Counter
Display
88
Factory Data
90 and Counter
Clear
V Correction
R
Reset
93
V Correction
L2
Reset
94
V Correction
L
Reset
95
Toner End
96
Force Cancel
Service Call
97 (E5) Reset
Total Counter
Clear
98
Factory use only.
Displays the total (electrical) copy counter.
*
The first three digits are displayed in the
magnification indicator.
Press the key to view the last three digits.
The mechanical total counter and the electrical
total counter may not always display the same
value, because of initial differences in the
counter values.
Factory use only.
Resets the drum residual voltage correction counter
*
for the VR correction.
To clear, enter "1" then press the
key at the same time.
Use this mode only after installing a new drum.
Resets the exposure lamp data and counter for the
V correction. Always perform this mode with SP95
L2
*
as a set.
To Clear, enter "1" then press the
key at the same time.
Normally not needed in the field, as this is handled
by SP48.
Resets the exposure lamp data and counter for the
V correction. Always perform this mode with SP94
L
*
as a set.
To clear, enter "1" then press the
key at the same time.
Normally not needed in the field, as this is handled
by SP48.

The Toner End condition is canceled forcibly.
By pressing the
toner end condition is canceled.
Resets a service call (E5) condition.
Turn the main switch off and on to check if the
service call condition is reset.
Clears the total (electrical) counter.
Normally, this SP mode should not be
performed.
*
To clear, enter "1" then press the
key at the same time.
To avoid resetting the counter by mistake, the
counter is reset only when the
key are pressed at the same time.
Function

key and the

key and the

key and the
key to enter this SP mode, the

key and the

key and the
4-21
PROGRAM MODES
Settings
0: No
1: Yes
0: No
1: Yes
0: No
1: Yes
0: No
1: Yes
*